Monday, May 9, 2016

Etherchannel Configuration & Troubleshooting



Cisco Etherchannel Overview and how it can be configured                            in Cisco Catalyst Switches 


Here lets go to congiure Etherchannel. First of all shutdown all Physical interfaces which u want put in Etherchannel
with shutdown command. 
like
#int range fa0/46-48
#shutdown
 

Now lets go to topology.

















ITKESW01#interface range gigabitethernet 0/45-48
                   #shutdown
                  #switchport trunk Encapsulation Dot1q
                 #switchport mode Trunk
                #channel-protocol lacp
               #channel-group 1 mode active

keep it shutdown until you configure the other side switch etherchannel interface.
Note: keep one side channel group active and other side passive this is the best method to configure the etherchannel interface.

ITKESWO2#interface range gigabitethernet 0/1-4
               #shutdown
                  #switchport trunk Encapsulation Dot1q
                 #switchport mode Trunk
                #channel-protocol lacp
               #channel-group 1 mode Passive

now shutdown both interfaces

#int range gigabitethernet0/45-48
#no shutdown

#int range gigabitethernet 0/1-4
#no shutdown

now it will create Port channel

If you have third switch attached then same config but u will create new channel for them. Suppose we have third switch name  ITKESW03 and that switch is connected to  ITKESWO2 , interfaces 5 and 6, and 3 and 4.

ITKESWO2#interface range gigabitethernet 0/5-6
                   #shutdown
                  #switchport trunk Encapsulation Dot1q
                 #switchport mode Trunk
                #channel-protocol lacp
               #channel-group 2 mode Passive

ITKESW03##interface range gigabitethernet 0/3-4
                   #shutdown
                  #switchport trunk Encapsulation Dot1q
                 #switchport mode Trunk
                #channel-protocol lacp
               #channel-group 2 mode active

now no shutdown both Switch interfaces.
and if u want connect third witch to ITKESWO1 
ITKESWO1#interface range gigabitethernet 0/7-8
                   #shutdown
                  #switchport trunk Encapsulation Dot1q
                 #switchport mode Trunk
                #channel-protocol lacp
               #channel-group 2 mode Passive


ITKESWO3#int range gigabitethernet 0/7-8
                   #shutdown
                  #switchport trunk Encapsulation Dot1q
                 #switchport mode Trunk
                #channel-protocol lacp
               #channel-group 2 mode active

commands for Etherchannel
# show etherchannel summary
#show etherchannel details
#show interface port-channel 1 etherchannel
#show etherchannel load-balance

if you want to see specific load balance on your port that you load balance is working or not .

Sw#sh int e3/0 | in packets output


if there is alot packets you cannot see clear just clear the counters.
#clear counters

No comments:

Post a Comment

Configure NIC Teaming in VMware First go to Windows Server 2012  then go to Server Manger Click on All Server then right click on your...